Product Description
ELIMINATES GROUT HAZE, CEMENTITOUS RESIDUES, EFFLORESENCE AND SALTS
FOR ALL UNPOLISHED NATURAL STONE AND PORCELAIN SURFACES (INCLUDING SENSITIVE STONES LIKE BLACK LIMESTONE)
ACID REPLACEMENT TECHNOLOGY (DOES NOT CONTAIN BRICK ACID)
PERFECT FOR ALL INTERIOR AND EXTERIOR WALLS/FLOORS
DIY FRIENDLY, DOESN’T DAMAGE SURROUNDING MATERIALS
REMOVES CEMENT DEPOSITS IN MINUTES
COVERAGE: This product covers approximately *per litre depending on substrate porosity.
*Light deposits: 25m2
*Heavy deposits: 15m2
*Undiluted: 5m
DIRECTIONS FOR USE
LIGHT DEPOSITS ON NON-ABSORBENT SURFACES: Dilute 1-part
ProJoint Eliminator in 4 parts cold, clean water. Apply with a cloth or
sponge. Leave for a maximum of 30 minutes. Extract released residues
using a sponge and water.
HEAVY DEPOSITS: Dilute 1-part PROJOINT ELIMINATOR in 1 part cold,
clean water. Apply liberally, if necessary, agitate with a scrubbing brush
or rotary scrubbing machine. Leave to react for 5-10 minutes, keeping
surfaces wet with additional PROJOINT ELIMINATOR mix. Extract and
rinse thoroughly with clean water.
IN EXTREME CASES: Pre-wet the affected surface with cold, clean
water and apply PROJOINT ELIMINATOR undiluted. Agitate with a
nylon pad, scrubbing brush or mechanical scrubber. Immediately
extract and rinse thoroughly with clean water.
Note, always dilute by adding Eliminator to water, not the other
way round. Not recommended to be used on polished surfaces or if
under floor heating is in operation.
IMPORTANT: Always test in a hidden area prior to use and only proceed
when satisfied with the results. The technical information supplied
is based on data obtained by our own research and is considered
accurate. However, no liability is accepted for any loss or damage
arising directly or indirectly from the use of our products, or from the
information given in publications. Prospective users should therefore
satisfy themselves by appropriate trials that the product is suitable
for the intended use. Do not discharge waste into drains or rivers.
Not suitable for use on surfaces that are highly polished, (i.e. polished
marble, travertine or limestone). Any contaminated surface should be
rinsed off immediately with plenty of clean water. Do not use when
under floor heating systems are in operation. Mask and protect any
surface not to be cleaned.
WASH HANDS AND EXPOSED SKIN AFTER USE.
